350z OEM Custom LED Headlights (03-09 350z) 350z Parts

Description: Freshly built OE Nissan 06-09 Headlights - Built in Show mode presets, Bluetooth controlled - Comes with everything shown - Fits 03-09 350z (Requires 8 Pin Headlight adapter, if car doesn’t have one already, Comes on 06-09 350z’s) - Center Hex LED Bluetooth Controlled with thousands of show mode custom presets - Outer LED Bluetooth Controlled with thousands of show mode custom presets aswell - Hex projector - Passenger Outer Bracket is broken as shown, And a small crack on the upper driver bracket, no other damages other than that - 1 LED Diode on top driver side corner of Factory DRL yellow LED’s is non functional (1 of the 4 Top corner LED diodes) - Will include bulbs and ballasts, were functional when tested, will not include accessories bulbs (Blinker, DRL Corner bulb) - Wires need to be extended to your liking, wires can be tapped into blinker to make LED’s sequential with your blinker (Or don’t have to be tapped into blinker, up to you, they are setup for it) - Once Wires are extended I highly recommend they are properly wrapped and to use a clear silicone Sealant on the fuse, Bluetooth Control boxes included with the wire setup - Wiring can be tapped into DRL’s so they activate once you flip the DRL switch in your car or what I’d recommend just tapped straight into your battery so you can keep them activated while your car is off aswell, will not drain your battery since these LED’s take very little power to stay on, Just don’t leave them on while your car is off for 5+ hours, battery will drain if not being charged my alternator of course - Please take care of these headlights as I will not be responsible for any type of damage you may cause to them or weather damage, reason why I recommend silicone sealing the control boxes and any other electric pieces that may get damaged from weathering, silicone will protect them and prevent any damage, keep these headlights sealed away from water and dirt is very important - Will NOT include both Headlights back caps you will need to purchase your own as they are fairly cheap and run a gasket or sealant around the caps once installed, will need to cut a square in the middle of them to run the RGB Wires through them, please use clear silicone to seal up the cut open squares once wires have been properly ran through them to keep water/debris from entering through - I can show you how to set them up and all the presets as I run the same style headlights on my Personal car - Most people/Companies Retail these $1,250+ range, so here I am once again bringing more affordable aftermarket parts to you at a discounted rate, price is set

Price: 885 USD

Location: Las Vegas, Nevada

End Time: 2024-08-23T21:01:10.000Z

Shipping Cost: N/A USD