1/2" 110 - 120 Volt AC Plastic Electric Solenoid Valve Water NPT 110V AC N/C

Description: Untitled Document 2 Way Normally Closed– Opens when powered120 Volt AC Solenoid Valve Function Normally Closed Connection 1/2” Inch NPSM Temperature Range 32 – 125°F Pressure Range 3 – 115 PSI Power Requirements 6 Watts *Suitable Media Water – Liquids Specifications Body Material Plastic (POM) Components Stainless Steel Seal Material EPDM Diaphragm Operation Type Direct Lift Valve Coil Connection Terminal Connection Orifice Size 8.5 mm Flow Rate 6 GPM @ 60 PSI *Duty Cycle 100% but not indefinitely Weight 6 oz Height 2.39" Length 2.85" port to port Width 1.65" Connection – No Polarity, + and – can be interchanged. The valve timing is uncertain, however it is fast acting. Less than one second. Mounting position is preferably coil up.*This valve has a straight NPT thread which requires a gasket connection to properly seal. Pipe tape may be used when making a connection to standard pipe thread. *Consult a chemical compatibility expert for correct seal and valve body material choice. *Duty Cycle – Like most solenoid valves the coil will become hot to the touch when left on continuously. The temperature will stabilize without failure. Leaving the valve powered on for long periods of time will reduce the life of the coil. Whenever possible the valve should be installed in a well ventilated are to increase the life of the coil. The valve is not intended to be left energized as a fail-safe for power outages. In this case please contact us for other options. A pre-filter is always recommended to keep the diaphragm free from debris and the valve functioning properly. Listing and template services provided by inkFrog

Price: 15.5 USD

Location: Centereach, New York

End Time: 2024-08-22T15:45:32.000Z

Shipping Cost: 0 USD